RAMSET 40088 Manual de uso y cuidado

THIS TOOL IS FOR USE ONLY BY LICENSED OPERATORS. YOU MUST OBTAIN A LICENSE BEFORE USING IT. A TOOL OPERATOR'S CARD WILL BE ISSUED TO YOU AFTER SU

4. Close tool by pulling the barrel back to the closed position. Never attempt to close the tool by exerting force on the front of the barr

TROUBLESHOOTINGTool operator must carefully follow all operating instructions and precautions to successfully operate the tool. Following is a list

DIFFICULTY PROBABLE CAUSE REMEDYUnfired load will not Load stuck in chamber Never attempt to remove an unfired, extract live load from the chambe

APPLICATIONS7/8" washer provides a greater bearing sur-face to the wood member, minimizing uplift.Fastener should penetrate steel completel

PARTS ASSEMBLYKey Part No. Description1 235101 Handle2 235201 Receiver stop3 235210 Receiver Assembly4 230103 Sear holder5 220205 Chamber6

CLEANING AND MAINTENANCEPROPER MAINTENANCE AND CLEANING INSTRUCTIONSMake sure the tool is not loaded prior to attempting disassembly or cleaning.ROUTI

REPLACING THE PISTON:The piston is an expendable tool part and must be replaced periodically. Breaking, bending, or mushrooming are typical signs of a

PISTON ROD REASSEMBLY7. Wipe off any excess oil and insert the piston assembly in the barrel. 8. Slide barrel assembly back into receiv

HOW TO SELECT A POWDER ACTUATED FASTENERDETERMINE FASTENER TYPEDrive pins are used to directly fasten an object (permanent installation). Threaded st

OPERATOR'S EXAMINATIONAfter studying and understanding the material in this tool manual, answer the following questions. Complete the

WARRANTYALL WARRANTIES OF THE PRODUCTS DESCRIBED HEREIN, EXPRESSED OR IMPLIED, INCLUDING THE WARRANTY OF MERCHANTABILITY AND FITNESS FO

LICENSE AND WARRANTY ACTIVATIONThe MasterShot™ Tool is warranted for 6 months after sale by ITW Brands.I certify that I have read and understand the M

SAFETY PRECAUTIONSWARNING! The following pages contain detailed warnings, cautions, and rules of safe operation with which the operator mus

1. Prior to using the tool, make sure it is unloaded and then do the functional check: Check the functioning of the tool, without a p

SAFETY PRECAUTIONS1. Always point the tool away from people and in a safe direction.2. Never use tool when explosives or flam-mable material

SAFETY PRECAUTIONS7. Never fasten into structural steel base material thinner than 3/16". Never fasten into concrete base material th

SAFETY PRECAUTIONS2. Never carry fasteners or other hard objects in the same pocket or container with powder loads. The loads could be se

SAFETY PRECAUTIONS2. Never unload or disassemble a jammed, stuck or broken tool which contains a live powder load. This may cause the

CAUTION!Be sure to read and understand all safety precautions and complete the Operator's Exam before attempting to operate the tool. Ch