RAMSET RAM 1000 Instrucciones de operaciones descargar pdf (Pagina 14)

TROUBLESHOOTING

14

TROUBLESHOOTIN G

SYMPTOM POSSIBLE PROBLEMS SERVICE

Preparing Tool for Operation—Battery/Charger Problems

Normal Stage of Operation

— Battery Cell does

not appear to accept

charge. Green charger

light does not come on.

— Flashing lights on char-

ger base unit.

— Fan does not run—tool

LED is off.

— Fan does not run,

or runs slower than

normal—tool LED is red.

— Fan runs intermittently.

— Inoperative indicator

lights on charger.

— Battery Cell damaged

or cycle life exhausted.

— Damaged charger.

— Damaged Battery Cell

— Battery Completely

Drained

— Battery Cell is not

charged.

— Magazine is loose,

preventing current

flow from Magazine

to Handle and

Cylinder Head.

— Magazine contacts

at top of Magazine,

or contact posts in

base of Handle, are

oily, dirty, or corroded.

— Battery Terminals or

Magazine battery

contacts are oily,

dirty, or corroded.

— Battery Cell is

discharged.

— Magazine is loose or

contacts are bent.

— Try Battery Cell in tool after 3 hours on

charge cycle. If tool LED is green, charger

lights are not working properly. Replace

charger, monitor charging time to ensure

Battery Cell has adequate time for recharging.

It’s normal for Battery to feel warm after

properly charging.

— Replace Battery Cell.

— Discontinue use immediately and unplug

from power source. Replace charger and tag

or dispose of charger to prevent accidental

reuse or connection to power source.

— Replace Battery

— Allow Battery to Charge for 5 minutes

— Charge Battery Cell according to Operating

Manual.

— Make sure Magazine is tight to nose of tool,

and secure with magazine Locking Knob.

— Clean contacts as required.

— Clean Battery Cell terminals. Clean

Magazine Battery Cell contacts as required.

— Charge Battery Cell.

— Tighten Magazine, or bend contacts up.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios