RAMSET T3SS Instrucciones de operaciones descargar pdf (Pagina 11)

QUICK CHANGE NOSE

The T3SS tool is equipped with a quick

change nose. This feature allows the user

to change the work contact element to

meet various fastening needs. The work

contact element can be changed without

the use of tools by following these steps:

Removal

1. Remove battery from the tool !!!

2. Firmly grasp the end of the

Work Contact Element and turn

it 90 degrees

3. Pull the Work Contact Element

from the tool.

Replace

1. Orient the Work Contact Element

so that the notched or flat portion

is toward the back or the tool

2. Firmly push the Work Contact

Element up into the nose piece.

3. Slightly twist the Work Contact

Element to be sure it is fully

engaged in the nose. NOTE: There

should be no open gap between the

shear block plate and the nose piece.

4. Insert the battery and operate

the tool.

Work Contact Elements

P/N: M150200 – To be used with fasteners

with pre-mounted 1/2” washers.

P/N: E150100 – To be used with straight

pins, fasteners with eyelets, and fastener

assemblies.

QUICK CHANGE NOSE

QUICK CHANGE NOSE

11

Turn 90°

Pull

Note gap,

rotate work

contact

element until

gap disappears

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comentarios a estos manuales

Sin comentarios