RAMSET Viper Tool Instrucciones de operaciones descargar pdf (Pagina 11)

TROUBLESHOOTING

REFER TO PARTS SCHEMATIC FOR PROPER ASSEMBLY OF PARTS

- Overdriving of fasteners - Excessive power - Change to next lower

power level load strip

color and number.

- Soft base material - Check base material

(see page 3)

- Tool fails to fire - Failure to depress - See “ Tool does not

completely completely depress”

- Excessive dirt buildup - After following misfire

on breech face not allow- procedure, check firing

ing proper penetration of pin indentation on load.

firing pin Clean breech face

- Firing pin and/or firing pin - Replace damaged parts

assembly damaged

- Tool does not completely - Misassembled or damaged - Check all parts in the

depress parts receiver for damage or

improper assembly.

- Reduction or loss of - Piston not being returned - Disassemble and clean

power to the full rear position barrel, piston and

nosepiece

- Worn or damaged piston - Replace damaged piston

- Failure to index strip - Strip not inserted in tool - Check load strip

correctly or is damaged Properly dispose of

damaged strip.

(See page 6)

- Damaged indexing mechanism - Contact your Ramset

Distributor for assistance

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

RAMSET Viper Tool Instrucciones de operaciones Pagina 11