RAMSET GypFast G2 Instrucciones de operaciones descargar pdf (Pagina 11)

FASTENERS

The GypFast (G2) tool can drive only ITW Ramset

fasteners. Any other fastener will cause tool

damage and void your warranty.

LOADING AND UNLOADING FASTENERS

1. Lay the tool on its right side, exposing the

gate latch.

2. Unlatch and open the gate. Swing open the

magazine cover.

3. Completely remove the blue tape from the coil

and unwind 1-2” of nails.

4. Guide the first nail into the drive raceway while

placing the coil of nails into the magazine.

5. Close the magazine and gate and you are now

ready to start driving nails.

To unload nails from a tool, first tear off excess

collation sticking out the front of the tool. Unlatch

and open the gate to remove the rest of the coil.

GypFast

(G2) TOOL

OPERATION

Proper technique

assures smooth

operation of the tool.

Three easy steps to

actuated the tool are:

1. ENGAGE THE TOOL

PLACE GypFast (G2) ADJUSTABLE NOSEPIECE

AGAINST WORK SURFACE. Then press down to

close tool.

Fan Motor will turn

on, LED will be steady

green. Fuel is injected

into Combustion

Chamber and mixed

with air by the Fan.

2. SQUEEZE THE TRIGGER The Spark Plug

sparks and fuel/air mixture ignites. Combustion

powers the Piston Assembly, driving the fastener.

3. RELEASE TRIGGER - LIFT THE TOOL

The Combustion Chamber opens. Fan exhausts

hot gases and cools internal components.

NOTE: If no additional cycles are made, fan will

run for 7 seconds and then shut off.

TO PREVENT UNINTENTIONAL TOOL OPERATION,

AND POSSIBLE INJURY TO YOURSELF OR

ANYONE IN THE WORKING AREA, BE SURE

TO RELEASE THE TRIGGER AS SOON AS YOU

HAVE FINISHED DRIVING FASTENERS. NEVER

PRESS THE ADJUSTABLE NOSEPIECE AGAINST

ANY OBJECT EXCEPT THE MATERIAL TO BE

FASTENED.

As the nails are being driven, the leftover collation

is fed through the nose of the tool. As collation

accumulates, it can be torn off by twisting and

pulling down on the collation. Keep your finger

off the trigger when performing this procedure.

DEPTH ADJUSTMENT

INCREASE DEPTH OF DRIVING FASTENER

To increase the depth of fastener rotate the

adjustment knob clockwise while holding the tool

with the nosepiece facing away from your body.

IF ROTATING THE ADJUSTMENT KNOB

“CLOCKWISE BOTTOMS OUT (CAN’T BE

TURNED ANY MORE) THE TOOL MAY NOT

FIRE. BACKOFF DEPTH ADJUSTMENT BY

ROTATING THE ADJUSTMENT KNOB TWO

TURNS CLOUNTER-CLOCKWISE.

DECREASE DEPTH OF DRIVING FASTENER

To decrease the depth of fastener rotate the

adjustment knob counterclockwise while holding

the tool with the nosepiece facing away from

your body.

PREPARING AND USE OF GYPFAST (G2) TOOL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios

RAMSET GypFast G2 Instrucciones de operaciones Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas RAMSET GypFast G2