RAMSET GypFast G2 Instrucciones de operaciones descargar pdf (Pagina 16)

SYMPTOM POSSIBLE PROBLEMS SERVICE

Power/Exhaust Stage of Operation

Returning/Purging Stage of Operation

If the GypFast (G2) tool will not operate after following the above service directions,

return the tool to an Ramset Distributor Sales Representative for service.

800-241-5640

www.ramset.com

— Battery is discharged.

— Fuel Cell is low.

— There may be loss of seal

in combustion chamber.

— Fastener strip may be

binding.

— Jammed fastener.

— Fuel Cell is low.

— Spark Plug wire is loose.

— Filter element is dirty,

causing tool to overheat.

— Tool Sleeve or Steel Rings

are dirty.

— Tool operates properly,

but fasteners do not

drive fully.

— Tool operates, but no

fastener is driven.

— Tool operates erratically

or appears to be

losing power—tool

LED is green.

— Charge Battery.

— Check Fuel Cell according to Operating Manual

and replace as required.

— Press Safety Yokes against workpiece for one

minute. Pull trigger. If fastener does not drive,

there is a leak that requires service.

— Use only fasteners meeting Ramset specifications.

— Clear jam according to Operating Manual.

— Check Fuel Cell according to Operating Manual.

— Contact Ramset Distributor Sales Representative

for Service.

— Remove Filter element and clean according

to Operating Manual. Use safe cleaning solution

to remove stubborn debris.

— Clean tool per Cleaning Procedure.

TROUBLESHOOTING

— Tool operated and

drove fastener, but

piston did not return

to start position.

— Tool does not open

after tool cycles.

— Built-up dirt and debris on

Piston or in Nose bore.

— Mushrooming of Piston Tip.

— Exhaust ports on the

Sleeve are dirty or clogged.

— Tool (Sleeve) or Steel Rings

are dirty.

— Tool is dirty.

— Clean Piston and Nose bore with safety solvent.

— Contact Ramset Distributor Sales Representative

for service.

— Return tool to Authorized Ramset Distributor Sales

Representative for service.

— Contact Ramset Sales Representative for service

— Clean tool or replace Work Contacting Element

as required.

1 2 ... 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios

RAMSET GypFast G2 Instrucciones de operaciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas RAMSET GypFast G2