RAMSET GypFast G2 Instrucciones de operaciones descargar pdf (Pagina 12)

SERVICING

Field service should be restricted to

the following:

qCHECKING THE ENERGY LEVEL

OF THE BATTERY

qRECHARGING THE BATTERY

qCHECKING THE FUEL CELL AND METERING

VALVE

qREPLACING THE FUEL CELL

qCLEANING THE AIR FILTERS

qCLEARING A JAM

Attempts to go beyond these procedures could

result in serious personal injury or damage to the

GypFast (G2) tool and voiding of the warranty.

There are certain problems that you may encounter

when you are using the GypFast (G2) tool that you

will be able to correct on the work site. The follow-

ing field service procedures are the only service

procedures you should attempt. Anything else

that may appear wrong with the GypFast (G2) tool

should only be diagnosed and repaired by a fully

trained service technician. If you have any reason

to believe that your problem is beyond the service

procedures in this manual, contact your Sales

Representative immediately.

DANGER

Never attempt any maintenance of the GypFast

(G2) tool without first removing the Fuel Cell and

Battery. Maintenance should only be started after

the tool is completely inoperative.

BATTERY CHECK

Periodically check on the LED Battery Voltage

Indicator Light—the LED in the Handle of the

GypFast (G2) tool. When encountering a problem,

the first step should always be to make sure the

Battery has enough energy to operate the tool.

If the light is red, recharge the Battery, If the light

is glowing green, indicating that the Battery is

charged, check the ignition system.

FUEL CELL CHECK

Another typical service condition will occur when

the Fuel Cell becomes empty. A typical symptom

will be when the GypFast (G2) tool’s Fan operates

and the LED is green, but the tool does not drive

fasteners completely. In this case, take the Fuel

Cell out of the tool, check to see if the Cell still

contains fuel and that the Metering Valve is

working. To determine is there is any fuel left in

the Fuel Cell simply place the Metering Stem

against a solid object, and gently push about

three or four times. A small amount of fuel should

be released each time. Never perform this test

near an open flame or sparks, while smoking, or

where the fuel may get into your eyes. If fuel is

not released with each operation of the Metering

Valve, there is no more fuel left in the cylinder and

it must be replaced. Dispose of the empty Fuel

Cell properly.

AIR FILTER

Open the cover by pressing slightly above the

Red Adapter, and pivoting the cover open. The

Air Filter simply lift out.

Tap the filter GENTLY to remove any dust. You

should check and clean the Air Filter every two

days.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios

RAMSET GypFast G2 Instrucciones de operaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas RAMSET GypFast G2